| Step | | Procedure & Parts & Tools |
| 1 |
|
REMOVE THE POWER CORD FROM THE CORD HOOK.
|
| 2 |
|
UNHOOK THE VAC HOSE FROM THE HOSE HOOK.
|
| 3 |
|
SLIDE UP ON THE BAG COVER LATCH. PULL THE BAG COVER FROM THE MACHINE.
|
| 4 |
|
PUSH IN ON THE RED LEVER ON THE RIGHT SIDE TO UNLOCK THE BAG.
|
| 5 |
|
PULL THE BAG DOWN OFF THE INTAKE HOSE.
|
| 6 |
|
REMOVE THE 4 SCREWS HOLDING THE UPPER VAC HOUSING.
| Screwdriver-phillips |
|
|
| 7 |
|
PULL THE UPPER VAC HOUSING UP TO SEPARATE IT FROM THE LOWER VAC HOUSING.
|
| 8 |
|
LOOSEN THE 2 SCREWS HOLDING THE GUIDE HOUSING.
| Screwdriver-phillips |
|
|
| 9 |
|
PULL UP ON THE TOP OF THE UPPER VAC HOUSING TO SEPARATE IT FROM THE LOWER VAC HOUSING.
|
| 10 |
|
LOCATE THE 3 WIRES ATTACHED TO THE VAC MOTOR. 2 BLUE WIRES AND 1 GREEN/YELLOW WIRE. INSERT 1 LEAD INTO A BLUE WIRE ON TERMINAL BLOCK. FOLLOW THE WIRE TO THE VAC MOTOR. INSERT THE OTHER LEAD INTO THE WIRE CONNECTOR OF THE BLUE WIRE. SET VOLT METER TO CONTINUITY. IF THE VOLT METER BEEPS, THE WIRE IS OKAY. CONTINUE THIS PROCESS WITH THE OTHER BLUE WIRE AND THE GREEN/YELLOW WIRE.
| Volt meter (True RMS capable) |
&Width=100)
|
|